SpeedFun RIBELLE for OLI and AM80 Atala

135,50

SpeedFun RIBELLE is an electronic and smart speed release device that needs no external power.

It is designed for use with OLIEDS, Oli Move Plus, Oli Move Sport and AM80-Atala, to circumvent the 25 KmH speed limit and allow for an increase in its active assistance up to speeds that can exceed 60 KmH by exploiting the motor’s power to the full.

Vedi di più...


Share

What is SpeedFun RIBELLE?

SpeedFun RIBELLE is an electronic and smart speed release device that needs no external power.

It is designed for use with OLIEDS, Oli Move Plus, Oli Move Sport and AM80-Atala, to circumvent the 25 KmH speed limit and allow for an increase in its active assistance up to speeds that can exceed 60 KmH (info) by exploiting the motor’s power to the full.

SpeedFun REBEL always shows real speed and mileage on display.

SpeedFun RIBELLE is equipped with a self-learning system to store all the parameters of the ebike on which it is mounted. Therefore no setting is necessary. Only a short initial sequence and then you can only think about having fun!

Speedup RIBELLE is assembled in a very simple way interposing it between the speed sensor and the motor and between the Display and the motor using original connectors that do not alter the characteristics of electrical resistance and watertightness.

The operation system starts operating only when the 16 kmH is reached, progressively reducing with a particular algorithm the communication of the wheel revolutions to the engine without the cyclist noticing any difference in assistance. It does not intervene in any way at low speeds. This is an important precaution designed not to vary the parameters of the engine intervention at the restart and in important climbs, (which are the critical and most delicate moments for an engine) thus leaving intact the parameters studied and optimized by the manufacturer, and thus avoiding loss of power, failures or “hiccup” operations that instead occur with the release systems of other manufacturers.

SpeedFun RIBELLE can be activated and deactivated with a sequence of keys (see here). A feedback is shown on the display, if present, each time the activation or deactivation status is changed.

 

The main features

– Totally INVISIBLE

– Shows real speed and mileage display.

– It can be dismantled and reassembled at any time

– It does not need any destructive modification to the original parts of the bicycle

– It allows to reach speeds with assistance activated even over 50 kmH (info)

– Installable in a few minutes, ready to use, plug and go!

– Suitable for OLIEDS, Oli Move Plus, Oli Move Sport and AM80-Atala

– Activated and deactivated with a sequence of keys (see here)

– Auto-learns the parameters of the ebike, memorizes and maintains the desired settings

– Internal firmware upgradeable to any new algorithms developed by the SpeedFun team. (It is necessary to send the device)

 

Assembly and Use Instructions

Connection diagram and instructions for use Rebel for OLI and AM80 Atala

 

Video Assembly Instructions

How to install SpeedFun Rebel ebike speed release OLI Sport chip kit SpeedFun tuning


This site uses cookies to enhance your experience. By continuing to the site you accept their use. More info in our cookies policy.     ACCEPT

ATTENTION, IMPORTANT NOTICE
Once the SpeedFun speed release device has been installed, the electric bicycle, if exceeding the limit of 25 kmH, is equated to a moped and as such, if traveling in public places, it needs to be homologated-registered by the Civil Motorization. subject to the payment of the road tax and insurance coverage, must have a license plate, cannot circulate on cycle paths and the driver is obliged to drive with a license and must use a helmet. In addition, driving a motor bicycle equivalent to a moped that does not comply with the aforementioned provisions entails the administrative seizure of the vehicle and financial penalties that vary according to the infringement committed. The manufacturer of the speed release system declines all responsibility for any damage caused to pedal-assisted bicycles on which the device is mounted as well as direct or indirect damage to people or things.
SpeedFun – Phase B snc declines any responsibility for any anomalies caused by the anti-tuning defenses that the engine manufacturers could activate.
Remember that the modification to the bicycle could invalidate the manufacturer’s warranty.

EBIKE SOFTWARE COMPATIBLE WITH SPEEDUP DEVICES
The operation of the SpeedFun devices is guaranteed for the software versions of the ebikes released up to the date of purchase of the device itself.
If the ebike is subsequently updated with software for which the SpeedFun device has not been designed, its failure may occur.
Before updating your engine, it is necessary to check the compatibility with your SpeedFun device.

NB: All the brands mentioned on this site are named exclusively to identify the models of engines and bicycles on which our devices are compatible. They are the property of the respective owners and are in no way related to our company.

Use your helmet, save your life!

Contact