View cart “SpeedFun FURIOUS for Giant” has been added to your cart.

Y splitter cable

15,00

Y splitter cable for OliEDS / AM80 lights output

When the ebike is equipped with headlights operated by the controls on the handlebar and then powered by the same battery of the ebike, it means that the light output of the engine is occupied for the connection of the same. To obtain an additional parallel output for the connection and operation of the FURIOUS device on / off lights, the Y splitter cable must be installed which allows an additional output to be obtained.

Installation is very simple, just disconnect the connector between the engine and the headlights and connect the Y-cable.

 

Vedi di più...
Clear


Share

Y splitter cable

When the ebike is equipped with headlights operated by the controls on the handlebar and then powered by the same battery of the ebike, it means that the light output of the engine is occupied for the connection of the same. To obtain an additional parallel output for the connection and operation of the FURIOUS device on/off lights, the Y splitter cable must be installed which allows an additional output to be obtained.
Installation is very simple, just disconnect the connector between the engine and the headlights and connect the Y-cable.

The Y splitter cable is available for the following engines:
– Y splitter cable for Ananda M100, Bafang Max Drive, Modest Drive and Yamaha PW, PW-X, PW-SE (CY-01)
– Y splitter cable for Giant Sinc Drive Life, Sport, Pro. OLIEDS, Oli Move Plus, Oli Move Sport AM-80 Atala (CY-02)


Additional information
Versione:

Version for Ananda M100, Bafang and Yamaha engine (CY-01), Version for Giant and OliEDS – AM80 Atala and Bianchi engine (CY-02)

This site uses cookies to enhance your experience. By continuing to the site you accept their use. More info in our cookies policy.     ACCEPT

ATTENTION, IMPORTANT NOTICE
Once the SpeedFun speed release device has been installed, the electric bicycle, if exceeding the limit of 25 kmH, is equated to a moped and as such, if traveling in public places, it needs to be homologated-registered by the Civil Motorization. subject to the payment of the road tax and insurance coverage, must have a license plate, cannot circulate on cycle paths and the driver is obliged to drive with a license and must use a helmet. In addition, driving a motor bicycle equivalent to a moped that does not comply with the aforementioned provisions entails the administrative seizure of the vehicle and financial penalties that vary according to the infringement committed. The manufacturer of the speed release system declines all responsibility for any damage caused to pedal-assisted bicycles on which the device is mounted as well as direct or indirect damage to people or things.
SpeedFun – Phase B snc declines any responsibility for any anomalies caused by the anti-tuning defenses that the engine manufacturers could activate.
Remember that the modification to the bicycle could invalidate the manufacturer’s warranty.

EBIKE SOFTWARE COMPATIBLE WITH SPEEDUP DEVICES
The operation of the SpeedFun devices is guaranteed for the software versions of the ebikes released up to the date of purchase of the device itself.
If the ebike is subsequently updated with software for which the SpeedFun device has not been designed, its failure may occur.
Before updating your engine, it is necessary to check the compatibility with your SpeedFun device.

NB: All the brands mentioned on this site are named exclusively to identify the models of engines and bicycles on which our devices are compatible. They are the property of the respective owners and are in no way related to our company.

Use your helmet, save your life!

Contact